I have a procedure created in my project explorer in HANA with input parameters. I activated this fine.
I am using the Debug Configurations to provide the location where the procedure is located and provide the input parameters as well. When I actually run it in debug mode, I see following message.
<terminated> New Configuration [SAP HANA Stored Procedure]
<terminated> usp_ofic_ins_pre_prcss.procedure
<terminated> Thread (Terminated(in usp_ofic_ins_pre_prcss.procedure))
Can't figure out what the issue is.
I have even created the procedure in catalog and debugged. same message. I am struggling with this for a week now.
Can somebody help me?
Thx
Ravi