Hello,
I have built a CA view ( graphical mode ) that is holding the logic I want to execute. The starting point of the logic in the CA view is a subset of a given table. Now I want to replace this static selection with an already available input provided by a procedure. However I do not find to achieve this.
When selecting the parameter type "Derived From Procedure" while creating an input parameter in the CA view I get the message "Procedure with output parameters of type Table not supported". I attached a screenshot of the message.
My case her:
- Procedure with table holding attributes "claimID", "subclaimID", "iinvoiceID"
- this table with preselected data should be starting point for the execution of the CA view
Any idea what to do ?
or any idea of a workaround ?
Best Regards
Gerd